Skip to main content
ExLibris
  • Subscribe by RSS
  • ExLibris Dev

    Voyager 7: WebVoyage: What is the start/stop order for Tomcat?

    • Article Type: General
    • Product: Voyager
    • Product Version: 7.0.1

    Desired Outcome Goal:
    Start and stop tomcat processes in correct order

    Procedure:
    After making certain configuration changes, you may need to fully restart the Tomcat WebVoyage interface for them to take effect.
    1. SSH to server
    2. Stop processes in following order; many sites use only vwebv and vxws and should skip the stop commands for vprimo and vpds below. Wait 5-10 seconds between each command to allow previous process to fully stop before stopping the next.
    /m1/voyager/xxxdb/tomcat/vwebv/tsvrctl stop
    /m1/voyager/xxxdb/tomcat/vprimo/tsvrctl stop
    /m1/voyager/xxxdb/tomcat/vpds/tsvrctl stop
    /m1/voyager/xxxdb/tomcat/vxws/tsvrctl stop
    3. Start processes in the following order, again skipping any processes not normally in use, again waiting to ensure each process comes up before the next is started:
    /m1/voyager/xxxdb/tomcat/vpds/tsvrctl start
    /m1/voyager/xxxdb/tomcat/vprimo/tsvrctl start
    /m1/voyager/xxxdb/tomcat/vxws/tsvrctl start
    /m1/voyager/xxxdb/tomcat/vwebv/tsvrctl start
    4. On newer Solaris 10 installs, there is an SMF service that does the same thing. For your xxxdb, run the following command:
    svcadm restart svc:/site/ExLibris/Voyager/xxxdb/Pwebvoyage:default

    Category: Opac


    • Article last edited: 10/8/2013
    //doorbell.io feedback widged